X-Man Bell corner cutting

[Toothcraver55]

So I recently lubed the core of my X-Man Bell pyraminx, and I can't find good tensions again. When I do corner cuts, whether they are reverse or forwards, I get some strange lockups. It seems like that means it's too tight but some pieces are catching and it feels kind of loose. I'm not sure whether to tighten it or loosen it, any ideas?

 

[2018AMSB02]

I have an X-man Bell, and I have never lubed it or done any work on it, and it is amazing. I am pretty bad at Pyraminx, and I average 8 secs. I would tighten the tips, and loosen the rest if I were you though.

 

[CornerCutter]

It sounds like you need to tighten it. Try turning the screws just a quarter turn at a time. Make sure they are all screwed in the same amount.

 

[cubezrawesome]

I have an X-man Bell, and I have never lubed it or done any work on it, and it is amazing. I am pretty bad at Pyraminx, and I average 8 secs. I would tighten the tips, and loosen the rest if I were you though.

me too

 

[Toothcraver55]

It sounds like you need to tighten it. Try turning the screws just a quarter turn at a time. Make sure they are all screwed in the same amount.

How can I make sure that they are all even?

 

[CornerCutter]

How can I make sure that they are all even?

Make sure the screws are all sticking up or down the same amount from the white piece. Does this make sense?