Turning cube less than 45 degrees in inspection?

[Chicken-Cuber]

Hello and I was wondering if it is legal to have a turn under 45 degrees during inspection and how it could be used if it’s allowed. Seems kinda op especially for 2x2 (sliding part 2???)

 

[AhsanDaCuber125]

Inspection is inspection. You can only inspect, not turn. If you do any turn, no matter what degree, it's a DNF

 

[EvanCuber1]

If you accidentally turn under 45 degrees and turn it back, I believe it’s fine, but if you like turn it to 45 degrees and put it on the table it’s a DNF