SS 6x6x6 alignment issues

[iamam2020]

I usually get my ss6x6 pop or the inner corner going stuck when I solving...
like this:

Spoiler: images

http://f12.wretch.yimg.com/pram/4/1...DdxVCNw9Zar5dalZTy_wyZ2RurdVZ3DBo1TUqCF1lLw--
http://f12.wretch.yimg.com/pram/4/1...DdxX_CNE9L.sckCIe1WFrZ8wCWg9w0W8LEWE3F2NLkA--
http://f12.wretch.yimg.com/pram/4/1...DdxWUXH8YlYUPZQcimkix9rguO3q5gfyF5iRDgXK6ew--

Does anyone body get the same problem??

And another question: How to practice 5x5, 6x6 and 7x7 cube faster , stably...:confused:

 

[JianhanC]

What do you mean? Is your 6x6 only able to turn on one axis but the other two is stuck? SS cubes are not supposed to do that, you'll need a more specific explanation to your problem. For big cubes, break in and lube your cube if you haven't already, and just lookahead. It might help your other big cube times to be good at one particular big cube though.

 

[emolover]

One or more of your center stalks became misaligned with the ridge that holds it in place. Take the cube apart fully and glue the centers so it doesn't happen again.

Also lube it while your at it.

 

[iamam2020]

Sorry, I mean when I solving my ss6 i usually get this problem... the image is just I do the same situation when I solving, like twist, dislocate....
I think my problem is about turning technic, not on the cube's. My ss6 is totally fine~
Maybe... all I need to do is practice!! can avoid this problem....
Because I saw the video on the youtube people can do very fast instead of pop... but when I turn I always get pop or stuck...

 

[JianhanC]

Modded or broken in well.