Square one hardware thread

deadalnix

Veteran
Joined
Apr 6, 2007
Messages
560
WCA ID
2008SECH01
Hi guys,

My question is quite simple. How do i get a good square one.

Mine is just terrible. However, it doesn't come from the brand I guess (this is a mf8, and many cuber have mf8 that really doesn't behave like mine).

So what is your favorite square one model, and why ?

How do you prepare your square one ? Which kind of lube do you use on it ? Do you use any special preparation ?

Anyway, post here any trick and tips, any review or basically anything interesting about square one. If enought things comes up, I will put them in this post to have a good overview of square one hardware al in the same place.
 
well there is only one speedcubing square-1 and that is the mf8. It's not that good at first but just break it in a lot and then lube it. I used Jig-a-loo.

How exactly is your square-1 bad?
 
Yup. Take out the springs, then tighten it just enough so that the edges don't lock up.

To lube, I take off a corner/edge cap and spray CRC inside on top of the track. It will feel bad at first, but once you work it in it'll be amazing.
 
Yeah take out the spring and lube it straight away. It'll be great. Personally, I like mine quite tight. But blade740 is a hell of a lot faster than me and has his quite loose so whatever.
 
Layers

My top layer is much tighter than the bottom layer. How do I fix that? My center caps don't seem to want to come off.
 
I disassembled mine completely and saw on the top and bottomw of the middle layer there were the Bumps that the layers rotated on so my process was to sand them off, sand each piece individually on every side and then to lube it let it air out for 45 minutes and reassemble it. I was getting about 1:20 avgs amd am now getting about :45 avgs
 
I have tested several mf8 and the quality is really reliying on luck. Some of them are just awsome and others can be crap. So it's quite hard to tell.
 
Back
Top