Solve only with Z-perms

[Lucas Garron]

A sim would be cool. Scrambles edges only. The controls? Hi-games rotations, with space for Z-perm

Ahem. It's sad when even the old-timers don't remember.

 

[qqwref]

I should make a qCube version of that (probably after I get the replay/reconstruction one working). It would be a lot more useful capped at 1000 tps than at 8...

 

[Tim Major]

Ahem. It's sad when even the old-timers don't remember.

Yes, I know about this, and sure scrambling works, but is there a way to set macros?

 

[d4m4s74]

Before I even saw this thread, I tried to solve with only U perms, I'll try the Z perm one when I'm at work

Okay, My first try took me about 15 minutes, I did not look at the "algs" on this page, will try again later

 

[Stefan]

Ahem. It's sad when even the old-timers don't remember.

Can't remember what I never used

Yes, I know about this, and sure scrambling works, but is there a way to set macros?

Don't you see the description on the right side of that page?

 

[Kirjava]

U perm would be much easier

 

[Tim Major]

Don't you see the description on the right side of that page?

Errr... Yes? Where does that mention macros? :confused: afaik the option to set algorithms to a key doesn't exist. I was asking.

 

[Stefan]

U perm would be much easier

It is, though I just tried and it did take me 3+ minutes because OLL was a ***** :fp
Then I used Petrus (as suggested for Z by someone else earlier) and got 1:41.

Errr... Yes? Where does that mention macros?

Seriously?

Just enter a Z perm as your only generator.

 

[qqwref]

You'll need two rotations as well.

Solving with U perms is a lot easier IMO. Probably faster too (and not just because U perms are faster to execute).