Skewb Pop

[CubingGenius]

My brother popped one of the centre pieces out of my Qiyi Qicheng Skewb. How do I put it back in?

I managed to get it back to solved position minus the missing centre. I don't know how to put the centre back in though. Could I please have some advice?

 

[DGCubes]

Rotate the Skewb 60 degrees (half a turn), and push the center in. There are two possible orientations to try, but only one will work, so make sure it looks like the center would fit in with the other pieces. If you're pushing really hard and it's not going in, take the center caps off and loosen it a little. The pieces will pull apart more easily so you'll have more space to fit it in. Once it's in, you can tighten it again.

 

[CubingGenius]

Rotate the Skewb 60 degrees (half a turn), and push the center in. There are two possible orientations to try, but only one will work, so make sure it looks like the center would fit in with the other pieces. If you're pushing really hard and it's not going in, take the center caps off and loosen it a little. The pieces will pull apart more easily so you'll have more space to fit it in. Once it's in, you can tighten it again.

Thanks, I got it back in after a while.

That was a relief.