person123
Regular
well not rubiks 4x4 too loose where it locks up a ton, but where it overshoots and its hard to keep the layers aligned ect.
So basically what happened was: so each ball core has those 8 notch type things. so what happened was that i tried to force a corner cut figuring it would go (with enough force like a screw spring cube), but then the cube basically exploded. but along with that was that one of those notch things broke off of the ball. I superglued it back on, but now the cube is too loose to my liking. Did i glue it on wrong? I checked if that particular notch was loose ( like you could move it side to side) but it wasnt. so i took the core apart and took off the notch again, cuz i saw it was slightly misaligned. i then glued it back on, aligned, and nothing happend. i think it might be the the notch is sticking up a little to high, cuz i noticed it was higher than the other notches, so i tried pushing it down but it's still slightly higher. Also, i tightened to screw to the max. Any ideas?
-thanks
So basically what happened was: so each ball core has those 8 notch type things. so what happened was that i tried to force a corner cut figuring it would go (with enough force like a screw spring cube), but then the cube basically exploded. but along with that was that one of those notch things broke off of the ball. I superglued it back on, but now the cube is too loose to my liking. Did i glue it on wrong? I checked if that particular notch was loose ( like you could move it side to side) but it wasnt. so i took the core apart and took off the notch again, cuz i saw it was slightly misaligned. i then glued it back on, aligned, and nothing happend. i think it might be the the notch is sticking up a little to high, cuz i noticed it was higher than the other notches, so i tried pushing it down but it's still slightly higher. Also, i tightened to screw to the max. Any ideas?
-thanks