New D type DIY help!

svampskallen

Member
Joined
Jun 8, 2008
Messages
7
Hi

today my type D DIY kits arrived from cube4you, and they works good. I also ordered some type A's. I have read about changing the core and so on, so I thought I would give it a try. But when I tried to unscrew the centerpieces from the type D, they wouldn't come off :S. Some did, but others didn't. I screwed, and screwed, and the screw was moving, but it didn't catch propperly.

So the problem is that

1, I cant adjust the tension on all sides of my type D's. None of them works.

2, I cant change the cores...

Has anybody experiensed this? I think it is weird... Please ask if you don't understand. Maybe I could make a video on youtube to show you what the problem is.

Any advice is welcome. Thanks.
 
Striped..? It is not almost off... It is stuck, and it doesn't move. The only thing that moves is the screw. Not the centerpiece, at all. And the screw just spins around, it doesen't go towards or against the core...
 
i also have that with many screws. it's because the D cores are made of stupid plastic. what you have to do is, put your fingers between the core and the centerpiece. and try to push the centerpiece as far out as you can, and keep the pressure on it, while you gently unscrew the screw. if it's still not working you need te push out the center even more. (like you want to push the screw out of the core without unscrewing). and if that doesn't work just cut the damn core in half :)
 
i got this problem too,its pretty common,what you do is take a really big scissors(those big ones i donno what its called) and basically CUT THE CORE OFF,and when some parts of the core is still stuck to the screw , you can easily use the "scissors" or pliers,and basically just hold it,and PULL IT OFF !.

but bear in mind u need to get a new core,and when u see,the screws will have super glue on it,clean away and jab them into ur new core and ure DONE !
 
Thanks for all the replys! And sorry for my slow reply. I have a work to do, some weeks in the summer, so I am a bit busy. But I'll try. THanks!
 
I pulled the piece as hard as I could. Or really, I pushed it. I grabbed on to the other pieces and then I pushed, with my thumb and third finger, as hard as I could on the stuck piece, and eventualy, it did come off :D. So now the cube is awsome :P thanks!
 
Sorry for stealing this thread, but I have a similar problem except, I can't tighten one of my screws in all the way resulting in the screw spinning as I turn the face and loosening it. Is there anything I can do about it? As I turn it more, the pieces will pop more easily.
 
I've checked the problem with the other screws on my cube and now I'm sure that it's a problem with the core. The screw just keeps on spinning and tightens up to a point where it'll just pop back onto the last row of threads. Also, this is my only DIY cube, so mixed screws shouldn't be a problem. Thanks for all the help though. Is there anything that I can do to secure it or should I go out of my way to buy a nylon DIY core and end up with a better cube? The price is something to be desired though, is there some place close to Toronto that I can buy from?
 
Last edited:
Back
Top