My stickerless Dayan Zhanchi 5 's core problem!

[Lunchb0ne]

So today I tried to open my Dyan Zanchi cube and remove the washers as I saw in a Vid , now as I have done all the cores , they've lost their springy feeling . Is this ok?
Btw , it was a pre assembled one.
[This is my first post so pls be nice ]

 

[Isaac Lai]

Errrr... isn't that why you would remove the washers in the first place? How is that even a problem?

 

[thelunarbros]

Many cubers consider spring noise to be a bad thing anyway, so it's essentially the opposite of bad. Unless you like the spring noise.

 

[Lunchb0ne]

No , I mean the cores don't retract so much anymore when pulled , this gives quite a stiff feeling to the cube and kinda makes corner cutting impossible

 

[GuRoux]

maybe loosen the cube a little.

 

[Berd]

Yeah you just need to lose the screws a little on each side, make sure it's even!

 

[Lunchb0ne]

I tried loosening (for God's sake lol) , but I still get that stiff feeling and also if I lossen more after that the prices on the face will start falling.

 

[Lunchb0ne]

Oh , I saw one DIY assembly tut and it seems that tighening the screws using the core does the trick , but I still get the stiff feeling from the yellow face , might be just the wierdo me .
BTW,TY for the fast response guys !!