EnterPseudonym
Veteran
These are the modifications to my Lingyun. Some turned out great, but others not so much.
V-Cube five mod: Recommended
The Basic V-Cube mod of the corners, I was inspired by Donovan's Lubix Ultimate cube, who was inspired by MeMyself&Pi. My thanks to both of them.
Center Ridge mod: Recommended
Very similar to the V-Cube 5 mod, except on the the small ridges of the center (where the center and corner touch at the end of the stalk). This mod takes only a little longer than the corner mod. This mod was used by nat4sail's "unpoppable" Lingyun, neither of us are exactly sure how this mod helps. Daniel?
Here is a picture of what it looks like:
Center "Point" mod: Not recommended
By point, I mean the 4 highest points on the center while upside down (excluding the stem, of course).
I DO NOT recommend this mod at all. I attempted to "level" all the "points". This was quite difficult, even with a file the points seemed uneven. The results on the cube had the opposite of the intended effect, it actually INCREASED POPPING. Instead of one piece popping i would have two pop.
DO NOT WANT, here's a picture:
Center corner mod: Not recommended
This is a simple mod of the center's corners. I did not experience any positive OR negative effects.
The picture:
Edge "wing" mod: Not recommended
I simply sanded down the "wings" of the edges.
On tight tensions this mod has no effects, however, on loose tensions this mod will cause the cube to lock up ~halfway through a large corner cut.
Before and After pictures:
Before:
After:
V-Cube five mod: Recommended
The Basic V-Cube mod of the corners, I was inspired by Donovan's Lubix Ultimate cube, who was inspired by MeMyself&Pi. My thanks to both of them.
Center Ridge mod: Recommended
Very similar to the V-Cube 5 mod, except on the the small ridges of the center (where the center and corner touch at the end of the stalk). This mod takes only a little longer than the corner mod. This mod was used by nat4sail's "unpoppable" Lingyun, neither of us are exactly sure how this mod helps. Daniel?
Here is a picture of what it looks like:
Center "Point" mod: Not recommended
By point, I mean the 4 highest points on the center while upside down (excluding the stem, of course).
I DO NOT recommend this mod at all. I attempted to "level" all the "points". This was quite difficult, even with a file the points seemed uneven. The results on the cube had the opposite of the intended effect, it actually INCREASED POPPING. Instead of one piece popping i would have two pop.
DO NOT WANT, here's a picture:
Center corner mod: Not recommended
This is a simple mod of the center's corners. I did not experience any positive OR negative effects.
The picture:
Edge "wing" mod: Not recommended
I simply sanded down the "wings" of the edges.
On tight tensions this mod has no effects, however, on loose tensions this mod will cause the cube to lock up ~halfway through a large corner cut.
Before and After pictures:
Before:
After: