For the type C. You just assemble like any other cube. Just spray a little lube in there and work it around. I'm assuming you use either Maplin or Tableau silicone spray. For Maplin, spray abit more in and work it around longer. If you use Tableau then you can just spray in the normal amount and work it in until it feels right. For tension, adjust the tension until it feels usable. Solve it a few times and everytime it pops, tighten it abit. Repeat.
For the C4Y cube. Assemble it and lube it like the type C. It may feel like you've tightened it all the way and it still pops like crazy but that's just because the core is unthreaded so just keep tightening. Don't use Tableau on C4Y cube. For me, it had very little effect. Use Maplin and spray in the standard amount and work it around for abit with a few solves.
Thats how I adjusted and lubed mine but I use Shock oil and Maplin silicone spray mix in my C4Y cube.
Oh and by the way...HAPPY BIRTHDAY! Haha ^^
Just spraying it in is not properly lubing, it might ruin your cube depending on the brand silicone (for example, jig-a-loo melts the cube a bit and might fuse the pieces)
answers as I know them:
Do not lube directly, solve it a lot of times so it grinds away any bad pieces.
you can try pestvic's method of breaking in if you want.
To lube, disassemble, lay out the pieces and spray a thin layer of silicone over them.
Then let it dry for ~20 minutes and assemble and do some solves.
If you want, you can take it apart after that and let it dry longer but that's not needed.
For the tension, tighten all screws about the same, then do some solves.
Hard turning, no pops: loosen a bit.
Good turning, no pops: pretty much perfect.
Good turning, pops: tighten a bit.
If it locks up a lot, try tightening it a bit more.
And of course, happy birthday!