Moyu 4*4 WeiSu 魔域威速

I sanded every point of contact on every piece but the trick is not to take off too much. The pieces are noticeably modded though in a good way. The feel of my Weisu just went from getting good to super broken in. The two different types of internal pieces were sanded lightly, just on contact points. The three other types were modded heavier. It's probably equivalent to doing thousands of solves. That's all any mod ever is.. Open your cube, find out where the friction happens, and reduce the plastic contact there.
The biggest difference now is that it has really quick speed at tighter tensions. I found that before the mod, the tighter you made it, the slower it got, and it was super hard to find a good medium tension. Now my Weisu is best of both worlds. Super stable, and fast with no pops.
I did it in two halves to avoid reassembling the entire cube which took a total of around 3 hours.
 
Last edited:
This sounds really interesting. Could you perhaps make a video showing the exact contact points that you sanded?
 
A video of the mod would really be nice :)
Also I've come to the conclusion that I'll keep using the weisu, it's still even better than my modded SS, which is already pretty awesome. The only real problem that I still have is the middle layer moving by itself. Is this more of a tensioning issue or could proper lubing help it?
 
Nilsibert said:
A video of the mod would really be nice :)
Also I've come to the conclusion that I'll keep using the weisu, it's still even better than my modded SS, which is already pretty awesome. The only real problem that I still have is the middle layer moving by itself. Is this more of a tensioning issue or could proper lubing help it?
Click to expand...

Put some lube in the outer layers. They stick when the inner layers are faster.
 
I just got a Weisu. I don't know what happened to it but on one of the slices I can't do a wide turn on it for some reason. I'm pretty sure I assembled it properly. My tensions aren't too tight. Any help?
 
gavnasty said:
I just got a Weisu. I don't know what happened to it but on one of the slices I can't do a wide turn on it for some reason. I'm pretty sure I assembled it properly. My tensions aren't too tight. Any help?
Click to expand...

Did you remove the stalks of the core when you disassembled? I'm not sure if the 'keying' on the stalks allows you to reverse it, but that would likely contribute to this issue if so.
 
Of all the cubes I watned for Christmas, this cube made the short list because of the raves about it and many switches to it as their mains.
 
You must log in or register to reply here.

Similar threads

C
  • Locked
LF: MoYu WeiSu Soft Spring Set - Pay $7!
Replies
2
Views
996
Ghost Cuber
Ghost Cuber
P
How to reassemble a Moyu Weisu 4x4?
Replies
4
Views
2,242
MoyuFTW
MoyuFTW
N
How to assemble a moyu WeiSu?
Replies
12
Views
2,709
~Adam~
~Adam~
Tanzer
  • Locked
Selling Florian Modded 5x5, Moyu Weisu 4x4, and Moyu Weilong V1
Replies
6
Views
2,143
FencingCuber
FencingCuber
SolveThatCube
WeiSu vs AoSu | MoYu 4x4 Comparison
Replies
0
Views
2,917
SolveThatCube
SolveThatCube
Back
Top