Lingyun V2 Problems

After a quick sanding of the bottom stem of the stalks, my LingYun v2 went from a "clicky" sound to making more of a quiet zzzick sound when turning. This is without the edge mod- just a good sanding of any nubs left on the bottom of the corner stalks.
 
try doing the 38 point edge mod and the centrepiece mod.

?? 48 point edge mod?

I think as Akuma said, the cube is only good with lubix or silicone... I wouldn't recomend buying it if you didn't have these lubricants. After about an hour of just casual cubing, the cube has settled down a bit and isn't so clicky. Still yet to sand down the excess plastic on the bottom of the corner stalks though, which I will do soon. I think the combination of tracks and torpedoes make the V2 really stable and great for corner cutting, but very rough, quite slow and extremely clicky.
 
I just want to inform you guys of the results of my modding. The V2 was quite clicky and loud when it was unmodded and wasn't broken in. I sanded down the place where the torpedoes run over the corner stalk so it was smooth, and did a little corner stalk mod, sanding and filing down the top of the corner stalk so it was more rounded rather than with defined edges. Now it has a small click because of the tracks but it feels a bit smoother. It is a little faster at high tensions (at low tensions it still pops often). Overall the feel has improved, but if you didn't like the feel of the zhanchi then you would hate this. I would describe the Lingyun V2 at the opposite end of the scale to the GuHong with the Zhanchi kind of in the middle (in terms of smoothness and clickiness). All have the potential to be fast and all have excellent cornercutting at any tension. I would say the GuHong has slightly less corner cutting than the Lingyun or the Zhanchi.

Ah... a miny review :D
 
I just got my Lingyun V2 as a DIY kit. I assembled it and lubed it with 3 in 1 silicone (my stickering was quite off :() After putting the center caps on I found I had two problems. One; my cube was EXTREMELY crunchy (very clicky), rough and slow (Even my badly assembled guhong was better). Two: when I went to loosen it so it would be faster, the center caps wouldn't come off. After much tugging and filing at the cap I managed to pry it off at the expense of one of my fingernails. I have since finished tensioning it to my likening but the center caps still bug me because every time I want to retension; I have to spend time filing and there is the possibility I would lose a fingernail.

IMHO the Lingyun V2 is a great cube, the corner cutting is pretty much equal to the Zhanchi but it is A LOT more clicky. Is there a mod I can do? (PS. I noticed that on the bottom of the corner stalks where the torpedoes contact, there are 3 nobs of plastic which probably need to be sanded down.

Thanks

I suppose you can use v5 corner mod becuz it works for the lingyun, as well as straightening the torpedoes so the are parallel and not crooked
 
Back
Top