How exactly should I lubricate my cubes with Jig-a-loo? # of sprays?

[lamecuber]

I tested out Jig-a-loo on my storebought and it didn't work so well. I popped out an edge sprayed 3 times and put the edge back in. Worked it in for 5 minutes. The next day, it seemed worse, it felt sticky. One day, I decided to just wipe my storebought clean of dust or something and after I did that, it turned amazing well.

So what's the best way to lubricate a cube with Jig-a-loo?

 

[lamecuber]

wait I'm new to these forums, I see that other's show up as questions... i started a post?

 

[4Chan]

???
My storeboughts love jig-a-loo.

I usually spray the surface of an edge or corner, and reinsert.
Sometimes if I'm lazy, I just put on the straw and spray in.
One of my old main cubes was a storebought.

 

[lilkdub503]

wait I'm new to these forums, I see that other's show up as questions... i started a post?

Yes. Yes you did start a thread. On the same note as Cubes=Life, my storebought absolutely loves Jig-A-Loo. I lubricated it two months ago and it hasn't lost much speed. Not only that, but I used the same lubrication in my Type A and it was slower than my storebought (sanded as well). The storebought still jams like a mo-fo, but the best approach may be disassembly, a sweep of lube, wait 5 minutes, then work in. It is nearly unbelievable.

 

[PatrickJameson]

Did you lube the cube with another lube first? And are you sure that it's Jig-a-loo? Because I'm in the same boat as the previous two posters; all the storeboughts I've used turn great with jig-a-loo.

 

[HowSuneIsNow]

I recommend using a small amount but applying more frequently. I apply a tiny drop to the surface of cubies directly and work it in. the less you use the less build up you get that's why it's important to apply directly.

 

[panyan]

i just spray until everything feels nice

 

[xXzaKerXx]

does anyone know where can i buy Jig-A-Loo in Malaysia (Selangor)?

 

[TemurAmir]

Maybe you put too much in... welcome to the forums!

 

[Inf3rn0]

Welcome to the forums.

Clean it out and re-try? All evidence says it should work well.

 

[DavidSanders]

I spray in my cube for 3 seconds after taking the edge out and then work it in by scrambling for about ten minutes.
Then I solve it a lot for an hour or so.
Then I get GREAT results.

 

[hyunchoi98]

"# of sprays"

It depends how long the 1 spray is.

I don't have jig-a-loo in my country but i think 2-4 short squirts should be enough.