[Help Thread] How do you take apart a Qiyi Warrior W?

[Krowa]

I solved the cube lots of times but when I tried to solve it once I couldn't and I found out it was unsolvable,
If someone could tell me how to take it apart please tell me because it's very hard to take it apart.

 

[AbsoRuud]

Make the screws really loose. Turn the top layer 45 degrees. Wiggle out an edge piece. The rest shold be easy.

 

[GenTheSnail]

Make the screws really loose

*Take off a center cap and unscrew a screw most of the way. There is some hardware underneath the screw so don't take the screw out all of the way*

If the unsolvable state is just a single corner that is twisted in place, then you don't need to disassemble it. Once the layer is loose, you can rotate the layer 45 degrees and then twist the corner with your hand. Tighten your cube back up and you should be ready to go.

 

[AbsoRuud]

*Take off a center cap and unscrew a screw most of the way. There is some hardware underneath the screw so don't take the screw out all of the way*

If the unsolvable state is just a single corner that is twisted in place, then you don't need to disassemble it. Once the layer is loose, you can rotate the layer 45 degrees and then twist the corner with your hand. Tighten your cube back up and you should be ready to go.

Good addon to my post. Agreed completely.

 

[Krowa]

*Take off a center cap and unscrew a screw most of the way. There is some hardware underneath the screw so don't take the screw out all of the way*

If the unsolvable state is just a single corner that is twisted in place, then you don't need to disassemble it. Once the layer is loose, you can rotate the layer 45 degrees and then twist the corner with your hand. Tighten your cube back up and you should be ready to go.

I have edges that aren't solvable, thanks for replying!

Make the screws really loose. Turn the top layer 45 degrees. Wiggle out an edge piece. The rest shold be easy.

I have took out the pieces but I'm having a problem putting my last edge piece back, (white blue piece).


EDIT; I have put the edge piece back, thanks a million for helping me!

 

[AbsoRuud]

EDIT; I have put the edge piece back, thanks a million for helping me!

Good job! Now screw the screws back in a little bit to get the right tension again and you should be good to go! Did you lube your cube?

I hope you get many more solves out of your Warrior W! It's not my main, but it's the cube I practice with the most. I really enjoy this puzzle.

 

[Krowa]

Good job! Now screw the screws back in a little bit to get the right tension again and you should be good to go! Did you lube your cube?

I hope you get many more solves out of your Warrior W! It's not my main, but it's the cube I practice with the most. I really enjoy this puzzle.

I enjoy it a lot too! Very nice budget cube. Thank you a lot!

 

[Ryan1992006789]

Just make the screw relatively loose, but not to the point where it comes out of the cube, because it's easier not to mess with all the hardware stuff. Then, generally you can just pull out an edge.