How do I prevent my DIY cube from constantly haveing pops

froglover284

Member
Joined
Jan 16, 2009
Messages
9
no matter how thight I make it the pecies are all falling out every which way, did I assemble it wrong? or is their some way to get less then like 5 pops a solve with this cube :/ It falls apart practicaly every time you touch it. Any advice?
 
Remove the washers or trim the springs. (but not too much)
This will drastically reduce pops.


Ive tested this and posted it in a thread before.
Try it and see.
 
O___o didnt I say I tried that???

Hmm, well I'm sure I can read a thread -- let's see shall we...

no matter how thight I make it the pecies are all falling out every which way, did I assemble it wrong? or is their some way to get less then like 5 pops a solve with this cube :/ It falls apart practicaly every time you touch it. Any advice?

Nope...

I am pretty shure it is type a

Nope, not there either...

thanks! and what do you mean trim the spring?? how much do I trim it?

Nope, you haven't mentioned that yet :D

Seriously though, if a typical 3x3x3 DIY doesn't tighten up when you tighten the screws you need a new cube.
 
tighten the screws and add more lube.

Unless you have a type AII like me, then you have no hope. Just 'expect' it to pop with any slight misalignment

lol, your A II must be pretty crap :p mine isnt THAT bad. although i sense i get more annoyed than most about pops. hence its recent disassembly. against a wall.
 
O___o didnt I say I tried that???

Yes you did.

Hmm, well I'm sure I can read a thread -- let's see shall we...

no matter how thight I make it the pecies are all falling out every which way, did I assemble it wrong? or is their some way to get less then like 5 pops a solve with this cube :/ It falls apart practicaly every time you touch it. Any advice?

Nope...

I am pretty shure it is type a

Nope, not there either...

thanks! and what do you mean trim the spring?? how much do I trim it?

Nope, you haven't mentioned that yet :D

Seriously though, if a typical 3x3x3 DIY doesn't tighten up when you tighten the screws you need a new cube.

I removed my washers from my DIY and the pops were drastically reduced. Try that.
 
Back
Top