[Member Intro] Hello I am Cuber

[Nir1213]

But my screws are loose but the centers are next to each other

just try it and see if you have any problems.

 

[codes&cubes]

what did you have to lean to get sub 20 i have bin averring 20 or 21 seconds

 

[BenChristman1]

what did you have to lean to get sub 20 i have bin averring 20 or 21 seconds

For me, it was full PLL. My averages jumped from around 18 with everything except the G perms to mid-16s with full PLL. LEARN FULL PLL!

 

[codes&cubes]

For me, it was full PLL. My averages jumped from around 18 with everything except the G perms to mid-16s with full PLL. LEARN FULL PLL!

i will but i hate algs

 

[Nir1213]

i will but i hate algs

then you can stay with 4LLL, maybe improving your f2l will work
But you should already know most of PLL around sub 30 so i think you should learn most of the PLL algs.
at sub 15 you should start learning full OLL.

 

[codes&cubes]

thanks will do

 

[Nir1213]

thanks will do

dont take my tips seriously tho people have their own path
i learned 4lll first before learning intuitive f2l although its better learning intuitive f2l first instead.

 

[Garf]

To lisCuber: Don't bother learning Roux. You basically need to learn COLL when solving the top 4 corners, after you finish the two 1x2x3 blocks.

 

[Nir1213]

To lisCuber: Don't bother learning Roux. You basically need to learn COLL when solving the top 4 corners, after you finish the two 1x2x3 blocks.

roux is good wdym
dont discourage him

 

[TheSlykrCubr]

CMLL is better in every way than COLL, and is probably actually better than PLL

 

[Garf]

Alright, sorry. But from experience, Roux is hard to learn. I still don't get LSE.

 

[TheSlykrCubr]

Alright, sorry. But from experience, Roux is hard to learn. I still don't get LSE.

LSE is really easy, bruh. did you even try to learn it?

 

[Garf]

Well, what I didn't get were the cycles. How the edges were cycled after the algorithm was performed. That's the problem.

 

[TheSlykrCubr]

Well, what I didn't get were the cycles. How the edges were cycled after the algorithm was performed. That's the problem.

 

[Garf]

Should have looked up this video.

 

[KyleTheCuber]

Welcome lisCuber!

 

[codes&cubes]

guys STOP!

 

[IisCuber]

Thanks for the help the cube is fixed also thank you for the Roux I average about 40 seconds with Roux.Any tips to for Roux.

 

[Nir1213]

Thanks for the help the cube is fixed also thank you for the Roux I average about 40 seconds with Roux.Any tips to for Roux.

i dont use roux so im not an expert on this area but i think blockbuilding is one of the hardest parts to do in roux so you can improve there almost certainly.

 

[IisCuber]

what did you have to lean to get sub 20 i have bin averring 20 or 21 seconds

Full Pll and OLL