Edison Cube help!!!

and my cube is totally gay now.

I haven't had any problems with my cube's sexual orientation.

he wants his cube to be happy?

lol yeah i need a happy cube so it'll want to move faster : )



meh, i had the same thing, just replaced the core with a type a core
now it just has center caps poppin everywhere

SEE. TOLD YOU :D :D :D :D :D :D

if not for the stupid center caps...it'll be my main cube hahahaha

Appearantly, n00bcubix and rachmaninovian's edison cubes are not happy.
 
Or you might drip one drop of super glue (make sure its the liquidy and runny kind) onto the core and blow it into the hole. This coats the inside of the core with super glue, and when it dries, helps to keep the screw in as it is harder to twist.
Loctite does the same thing, just that you don't need to wait for the loctite to dry to screw in the screw. You must, however, wait for a few hours for it to dry.

hmm, do you put the screw in after the super glue dries or before it dries(when its in liquid form?)

Also, where can I get loctite from?
 
DON'T USE GLUE

I don't know why everyone immediately wants to use glue, there IS a better solution.

Plumber's Tape (aka Teflon tape) is a thread seal tape, it's not sticky it's a thin white ribbon that you put around the thread of your screw, and you can continue to alter the screw and it will not loosen on it's own.

You can pick it up for very cheap in any DIY shop.

Here's a picture:
728px-Gjengetape.jpg
 
Last edited:
Back
Top