Cube4you Cube Help

Corpsez

Regular
Joined
May 10, 2009
Messages
188
Location
Corona, California
I have 2 purple cube4you brand diy's. They are set to about the same tension coincidentally. One cube feels very smooth. It doesnt feel like it catches on anything and feels like "butter". Thats the best way to describe it. On the other hand, my other cube feels like it catches a lot. It sounds very crispy and it is starting to get annoying to cube with.

Any suggestions on how to make this one like my first? I did no modifications to them at all. Just lubed and tension.
 
Make sure you put all the edge and corner caps in all the way.
Yeah that is most likely the problem. Probably the edge caps on of the edges are in incorrectly. If you put them in the wrong way it's a pain to get out :mad:

This happened to me like 3 times (I had like 8 Cube4you DIYs I was assembling).
 
Make sure you put all the edge and corner caps in all the way.
Yeah that is most likely the problem. Probably the edge caps on of the edges are in incorrectly. If you put them in the wrong way it's a pain to get out :mad:

This happened to me like 3 times (I had like 8 Cube4you DIYs I was assembling).

Hmm I know its not the corner and edge caps because I put them all on firmly
 
Maybe you just got the short end of the stick and received a bad cube. Just a guess though, there may be a way to fix it, but if the caps are on correctly then I don't know what else the problem would be. Maybe try taking it apart, cleaning it, then reassembling. When I say take it apart I mean like ALL the way, like screws and everything, then start over like you just got it.
 
Make sure you put all the edge and corner caps in all the way.
Yeah that is most likely the problem. Probably the edge caps on of the edges are in incorrectly. If you put them in the wrong way it's a pain to get out :mad:

This happened to me like 3 times (I had like 8 Cube4you DIYs I was assembling).

Hmm I know its not the corner and edge caps because I put them all on firmly
IT's not if you put them on firmly. It's if you put them in CORRECTLY. Check the edge caps, see if any are sticking out like a milimeter or something. The lower part of the edge cap, if it makes any sense.

I'm very sure that is your problem, the unsmooth (clicky) feeling is exactly what happened to me. If you still don't know what I'm talking about, I'll take some pictures.
 
Make sure you put all the edge and corner caps in all the way.
Yeah that is most likely the problem. Probably the edge caps on of the edges are in incorrectly. If you put them in the wrong way it's a pain to get out :mad:

This happened to me like 3 times (I had like 8 Cube4you DIYs I was assembling).

Hmm I know its not the corner and edge caps because I put them all on firmly
IT's not if you put them on firmly. It's if you put them in CORRECTLY. Check the edge caps, see if any are sticking out like a milimeter or something. The lower part of the edge cap, if it makes any sense.

I'm very sure that is your problem, the unsmooth (clicky) feeling is exactly what happened to me. If you still don't know what I'm talking about, I'll take some pictures.

They look the same as my other cube4you cube that is smooth.
 
Look at the areas of the where the red arrows are indicated. Make sure the cap is all the way in, if it's EVEN A MILLIMETER higher than it should be then it's in wrong. Sorry I don't have pictures of the edge caps in wrong though.

Look through all twelve edges in the cube, on both sides of each edge, and make sure none are popping out even a tiny bit.

Edge2.jpg


Edge1.jpg
 
Back
Top