Cube Screwed Up By Silicone

Statical

Regular
Joined
May 3, 2008
Messages
143
Location
Singapore
YouTube
Visit Channel
Hey does anybody experience this problem? the cube gets gummy and sticks together and locks after spraying silicone over the cubies one by one. if so is there a solution for this?:confused:
 
A lot of brands of silicone spray will make your cube sticky for a while until you let it dry thoroughly and give it a few days of breaking in. You could also try wiping it off and trying again, but don't use so much next time. Spraying each piece individually is probably applying way more than you actually need.
 
You can try what I do, spray a bit on your finger tips, rub it on the non-stickered part of the cubie, give it a couple of seconds to dry, rub the white powdery stuff off with a old t-shirt, pop that baby back together, have fun.
 
If you used a spray silicone with petroleum products in it, it is likely eating your cubies. I did this and when I noticed that it was sticking, I disassembled the cube, wiped down all pieces and the core with Simple Green, then re-lubed with a non-petroleum containing product. Now all is well.

If you're not sure, read the ingredients list on the side of the can. AFAIK, if it says "food grade" on the can, it won't have any harmful petroleum (or other) products in it that can eat the plastic.

Brian.
 
wait, ive been using a combination of silicon based lubricant and a tiny spray of pam (barely any and not enough to hurt it, seriously not even a spray) and it works wonders and lasts long. is that bad?
 
hmm u might have sprayed too much, just take it apart and let it dry. After a while, (maybe even a week) it will be fine.
 
My cubes get gummy over time too. Could it be the dish washing liquid I use when I wash my cubes?

I put a few inches of water in the sink, then add a small squirt of dish washing liquid (to cut the oils away), then plop all the cubies + spindle into the water. I swish them around vigorously, then empty the sink and refill it once or twice to make sure the detergent is gone, and rinse them. Then one by one, I remove each piece, shake the water out, and blow the tiny droplets out. I stretch the spindle and do my best at blowing and shaking the water out from the cap areas. I assemble the cube randomly, then gripping it tightly, I use a whipping motion to extract more water out. Then I remove a row of cubies, and wipe more droplets away as I turn the face 90 or 180, then turn an adjoining face.

I check pieces carefully to see if I need to file little nubs away, or wipe stubborn crud away.

If I am lazy, I just spray 100% silicone spray into the area where I remove a row of cubies. I might turn faces by 180 so the gap is on the other side of the cube, and spray again.

If I have time, I lay them carefully on damp paper towels, with tiles against tiles, then spray, rotate, spray, wait until dry before assembling. Note, stickers get destroyed if silicone gets on them.
 
I find that letting the lube stay on for a long period of time damages the cube so I leave it on for 15 minutes and then wipe off the excess. The results are excellent and there is no damage to the cube from puddled silicon; the avoided damage isn't that bad but it does "scuff" up the surface which I can avoid by wiping off.
 
Back
Top