Cube problems

Joined
Jan 5, 2015
Messages
11
So I just ordered my new Moyu weilong V2 hopeing for a cube upgrade. Before the weilong V2 came in I had a Dayan zhanchi that I still have and it is very fast and very broken in but is starting to get old so I ordered a new Moyu weilong v2. It was pretty good out of the box but not as fast as I thought it would be, but I thought if I tensioned and lubed it, it would fix the problem. When I lubed the cube I used the crazybadcuber tutorial on youtube and then I tensioned it so it could cut 45 degrees on all sides and sometimes a little more. But the one problem that isn't fixed is how slow the cube is, it seems to be like 1/6 the speed of my Zhanchi and is almost similar to my rubiks brand. I use weight 3 lube on the core and the pieces so I wasn't expecting it to my really fast considering that weight of lube isn't that fast. But it still seems very slow so I am just wondering if I did something wrong or what's the problem? I am pretty sure i didn't use to much lube or to little so I am not sure why the cube is so slow. Will it get better if I keep solving it and break it in? Any Suggestions?
 
yea, that's what I'm doing and its a little better, but still not as fast as what everyone is saying. I just ordered a lighter weight lube for the pieces because that's where it seems the slowest. It feels like there is a lot of friction between the pieces, so hope this will help. Also my tensions are not adjusted to tight.
 
Back
Top