Is it necessary to have corner caps? Because one of my type D's corner did not have one and I can't contact the person who sold it because I used one of those rewards sites...
du kannst mein corner cap haben, ich hab eines zuviel, schreib mir halt mal bei msn die adresse, dann schick ich es dir, aber erst so am samstag abend, weil bis dahin bin ich noch weg
du kannst mein corner cap haben, ich hab eines zuviel, schreib mir halt mal bei msn die adresse, dann schick ich es dir, aber erst so am samstag abend, weil bis dahin bin ich noch weg
To translate this: give him your adress at msn and he sends you his, he got one too much. But he can't send it before saturday evening, because he's not at home till then.
And David, this is an english forum....
My storebought cube lost one too, I glued it back because I don't think that it is good, because you can probably get into that spot with something, either your finger or another cubie....
Take some cheap modeling clay or putty. Roll it out and press the corner into it. You'll need to figure out a way to smooth it out to match the rest of cube's running surfaces.
I lost a couple of mine and other cubies get stuck inside sometimes. There was this one time I didn't clip my nails and I broke it because it got caught inside, it hurt, but it didn't look too bad.