byu
Veteran
So, I'm just doing small adjustments on my DIY, but it seems to take a long time to take apart the cube, take off the center caps, make the adjustments I want, and then reassemble it. Is there any quick way to remove center caps?
Center Cap Removal?
- Thread starter byu
- Start date
pcharles93
Veteran
I would take a knife and carve out a little groove out of each cap.
cookingfat
Veteran
i just flick them out with my thumb nail
byu
Veteran
Your nails must be sharp! It hurts my nails to flick them out. Or maybe the center caps on your cube are just really loose...
d4m4s74
Veteran
I usually use an xacto knife
JTW2007
BattsMan
You could get a type C. They have little notches in them to make the center caps come off easier.
cookingfat
Veteran
not really, my centre caps come out relatively easily on my cube (AII), but they don't fall out on their own.
JohnnyA
Veteran
My yuga has very bad centre caps, but the competition cube from PUZL.co.uk has little notches to get them out easy. I use the sticker remover from cubesmith to take out my yuga centres.
clarubik
Regular
I can't get the center caps off me ghosthand what should I do
Edward
Veteran
- Joined
- Oct 17, 2009
- Messages
- 2,497
- Location
- Your default internet browser
- WCA ID
- 2011KING01
- YouTube
- Visit Channel
Use a kitchen knife, stick it into the little seam, and pry the cap out. You can also use a razor blade, but I wouldn't recommend this (almost destroyed my finger using a blade).
clarubik
Regular
okay thanks I will try it
