7x7 Too Tight

Okay, BACK on topic...

Maybe you should try lubricating it without taking it apart. As the surface of the plastic dissolves & you start to work it all in, it will reform that plastic & get it all very smooth. Though I found that there is little air circulation in the V-Cubes, so if the cube seems to stiffen up even more, try taking out maybe a corner section of pieces & blow into it. That should dry up any remaining silicone.

If you still aren't satisfied with it, maybe you should putting dirt/sand/tooth paste in it & work it in really good! Then lubricate it again & smooth out those rough spots in the plastic.

Hope that works for ya!

Toothpaste?
whitening toothepastes have abrasives to grind away stains, learned that on mythbusters...
 
Haha I had the same problem. During about August of last year I had a white 7x7 that was pretty tight, and I had a competition September and I needed to break that cube in.

I remember taking it apart once entirely and jigalooing it and that did dissolve a lot of plastic. I also tried shock oil even though I hated shock oil lol. But the jigaloo did make it easier to turn, and I was just doing a lot of solves and trying my best to break it in.

The cube did get better later that month and it was actually really nice and I did well with it at my competition.
 
Back
Top