7x7 Too Tight

JoshPriebe

Member
Joined
Feb 5, 2010
Messages
3
Location
Indiana
I bought a white 7x7 for christmas, and when i got it and used it a bit it seemed tight and hard to turn. I assumed this was just cuz it needed some breaking in. About a month in, it was still tight, so i lubed it with silicone spray.(disasembled, sprayed, waited, reassembled) It felt a bit better, it sorta glided, but still was hard to get started turning. I checked out my friends black 7x7, and it seemed much looser. So then i completely washed all the crap out of it (disassembled, dishwashed, reassembled). it still felt tight.
Forgive the noobishness.
Please help.
 
I would just keep lubing it and breaking it in. I was going to say sand each piece but that could end up badly. Just keep working at it.
 
I've had this problem with my v-5 too..

What I did is, I disassambled it and I sanded
down all the imperfections I also made the
corners a little smaller at the base of the piece
and the middle-edge piece at the base.

Than I lubed the cube

now my cube turns awesome

,boaz
 
My black V7 arrived loose. Both my white V7s arrived tight. Silcone shock oil helped loosen the white cubes. (I suspect silicone spray would work better, but I figured that would require disassembly for best results, and I was too lazy to consider reassembling such cubes.)
 
I bought a white 7x7 for christmas, and when i got it and used it a bit it seemed tight and hard to turn. I assumed this was just cuz it needed some breaking in. About a month in, it was still tight, so i lubed it with silicone spray.(disasembled, sprayed, waited, reassembled) It felt a bit better, it sorta glided, but still was hard to get started turning. I checked out my friends black 7x7, and it seemed much looser. So then i completely washed all the crap out of it (disassembled, dishwashed, reassembled). it still felt tight.
Forgive the noobishness.
Please help.
i told you you should've gotten a black one
BTW thats my black V7 he was talking about
 
Since i know you are all waiting for it, thats what she said

ok moving on, i just need some lube and breaking in
 
Okay, BACK on topic...

Maybe you should try lubricating it without taking it apart. As the surface of the plastic dissolves & you start to work it all in, it will reform that plastic & get it all very smooth. Though I found that there is little air circulation in the V-Cubes, so if the cube seems to stiffen up even more, try taking out maybe a corner section of pieces & blow into it. That should dry up any remaining silicone.

If you still aren't satisfied with it, maybe you should try putting dirt/sand/tooth paste in it & work it in really good! Then lubricate it again & smooth out those rough spots in the plastic.

Hope that works for ya!
 
Last edited:
Okay, BACK on topic...

Maybe you should try lubricating it without taking it apart. As the surface of the plastic dissolves & you start to work it all in, it will reform that plastic & get it all very smooth. Though I found that there is little air circulation in the V-Cubes, so if the cube seems to stiffen up even more, try taking out maybe a corner section of pieces & blow into it. That should dry up any remaining silicone.

If you still aren't satisfied with it, maybe you should putting dirt/sand/tooth paste in it & work it in really good! Then lubricate it again & smooth out those rough spots in the plastic.

Hope that works for ya!

Toothpaste?
 
Back
Top