4x4 Lubrication

apostolis159

Member
Joined
Aug 28, 2010
Messages
19
Location
Greece, Larissa
Well, I have a Rubik's 4x4 (new core I think, but I'm not sure). How can I clean the inside and what is the best lubricant? May I use vaseline, silicon or silicon oil?:confused:


Thank you for helping... :)
 
ditch the Rubiks brand and get something else if possible. They're aweful. I had two break within two weeks and the first broke in less than 20 turns. I hadn't even scrambled it for the first time so if a totally mint cube breaks in a few turns it really says something about quality.

If you can get a new 4x4 I have a Dayan that I lubed with Lubix and it's magic. It's pretty loose and pops some but not a ton. Get the Dayan or Maru

If you can't get a new 4x4 then to clean it you have to pop a dedge (probably just a wing since Rubiks 4x4s are usually super tight) and then from there carefully disassemble it. Then wipe down all the pieces and if there's a lot of dust in the core just run it under water. Or even better if you have a shower head that's really powerful or can shoot out the water at different settings use that and blast away the dust. Make sure it's totally dry before reassembling your puzzle.

As far as a lubricant goes it depends. What do you have available? If you can afford it Lubix is fantastic on every cube that I've used it with (A-V, Guhongs <-- especially GuHong, and Dayan 4x4) If you don't have any lubricant on hand like CRC or Jig-a-loo or any of the other highly recommended brands then I, personally, wouldn't lube it until I could get my hands on something a little bit more legit than vaseline or WD-40
 
It isn't planned to get another cube yet, so I'm stuck with this.:/ I don't have, but I can find CRC. So I just remove an edge and spray and then the opposite edge and work it out, or spray the core when disassembled?
It haven't popped yet but I don't want it for speedcubing. I just want to make it move! It locks up A LOT and it's very difficult even to turn it sometimes...
 
I recommend you take the cube apart and spray down all the pieces, flip them, spray again, repeat until totally all are sprayed. You have to wait until the spray has dried before you can flip them. You can just pop a piece and work it in but I'm not sure how that will work out in the end. I'm not sure if it would help with a 4x4 but you could maybe put sand in it and just work in the sand. It'll grind away some of the plastic and hopefully make it smoother. Clean it out and give it a few solves. If it's still rough get a finer grit sand and repeat.
 
Back
Top