Lubricating Rubik's 4x4

byu

Master
Joined
Dec 18, 2008
Messages
2,021
Location
California
WCA ID
2009YUBR01
YouTube
Visit Channel
So, I finally fixed the center cap of my Rubik's 4x4 that was broken. But now, it's just crazily stiff. I bought some silicone spray two days ago, and I was wondering if I can just take the core and spray some of the lubricant on the core and then just put back the pieces right away. I want to make sure that this is an OK thing to do, because whenever I don't check to make sure something will work, it never does.

I'm bad with hardware. Before I bought a DIY, I put WD-40 in my storebought 3x3. The core broke in a few days.
 
yes, it works, put VERY little in it though... rubiks brand 4x4s go crazy loose to a tiny amount of lube.
 
Take it apart, clean off everything, reassemble it, spray silicone in after taking an edge pair out, do that for three edge pairs, solve it a couple times, then look at your times, go buy a mefferts, and become insanely fast.
 
eastsheens DIE at my hands...
I've killed 3 ES 4x4s in 3 months..
my mefferts is barely alive after 3 months...
basically its like 8.3SGD/month for a mefferts, and 24.95SGD/month for eastsheens...booo...
 
Last edited:
they just die. eastsheens are fine out of the box but get worse and worse over time.

either way, the meffert's, in most opinions (and mine) is just a better cube in every way. you will not be disappointed with it.
 
Killed meaning, they fell apart completely and needed reassembling?
Or that they actually "broke"

Don't worry about him. He uses a cage method. Your cubes won't die so fast if you use reduction, turn gently, and don't practice 4x4 crazily.
Both my Meffert's and Eastsheen are alive and well, just hidden by my parents until after I take the AP exams...
I'm about 30 seconds faster on http://hi-games.net/cube-4x4x4/
than on my Meffert's. I haven't touched an Eastsheen in months, but in my memory, they are good cubes that aren't any worse than Meffert's. When I first switched, I was actually faster with the Eastsheen by about 10 seconds (when I was averaging about 130s).
 
I lubricated my Rubik's 4x4 the way you guys told me to. Thing is, the outer layers turn terribly (worse or the same, i can't tell) and the inner layers and double layer turns are really good. I suppose there is no way around this?

I guess I'll have to get an ES or Mefferts 4x4
 
killed meaning - got too loose, or pops :D I was just being an idiot, so don't worry about me :D =P =P

I was talking to [EDITED: for reasons :D] of rubik's products here in sg - He says that rubik's uses high quality ABS, JUST THAT there must be problems with the molding processes - the molds wear out after being used repeatedly. without good molding rubik's puzzles SUCK. :D

well well well the best rubik's 4x4 I had was from the october/november 2007 batch.

Just get a mefferts :D
 
Back
Top