modding

Post this kinda stuff here

If you added a little backstop (just a small lump of metal) to each of the six arms that form the core of a cube, so there's a backstop just below each centerpiece, the backstops would prevent the springs inside the centerpieces from pushing the centerpieces inwards any further than the position...

Last night I had an idea of swapping the ball-core and the core magnet pieces (from the corners) from my RS3M V5 Ball-Core UV and transferring that to the RS3M V5. I thought it was a good idea, I might do it today. Here are the pros and cons: Pros: Now it’s a MoYu ball-core cube with frosted...

I know that this is a little bit off topic, but please continue reading. I’m currently modding a 5x5 to make a 5x5x3. I’m considering cutting the top and bottom off, but that needs epoxy filler. Is it worth the danger? How should I handle the filler?

This is the thread for lube setups, preferred tensions, settings, mods, etc. for all types of cubes. You can request, just post normally, give tips, and everything in between. I'll just kick this off right now with my preferred setups. For all my cores, I drop in any lighter lube and break it...

I want to dye the yellow side of the yuxin squan black and i'm not sure how to do it while keeping the feel of the plastic the same. I have considered rit dye.

I've looked in the forum but i couldn't find a thread or a comment about this, so please if you know about one that already exists, please refer me to it. The thing is that I wanted to learn a bit more about modding, but i can't find a tutorial about HOW to extend pieces. I've seen people...

Hello, I am already planning to make basic 3x3x3 mods. I have a Dremel, Milliput, etc. My big question to you all, is how to make cuboids? I have seen Ian C's videos on the matter, but I am still utterly befuddled as to how to build the following cuboids. Please could someone reply with...

I'm pretty new to modding. I've only had experience with the Florian mod. I want to get into making puzzles out of other puzzles, which usually involves filling, extending, and a lot of sanding (not in that order haha). I understand everything except the extending. What do you use for it? Why do...

This is an Arduino project I made that uses a Rubik's cube as an input device for gaming.

This is a post with some pictures (and way too much explanation) about a cube I modded, and lost. http://awesoham.wordpress.com/2014/02/04/the-glyphcube-my-epic-rubiks-cube-mod/ :)

Hi, I've recently tried modding ny old Rubik's storebought to make it a little better. I'm planning of: Sanding down internal parts Making 'RCC' holes (simular to a Dayan) Replacing stickers Replacing core/springs/screws My question is: What brand of stickers/core/springs/screws would...

Hi this will be a thread on any modded cubes you have. You can share pictures here too. I'll start w/ an "elite" I just made. Here are my mods. Keep clicking on next to see the other pics.

If you're modding a v-cube 7, what exactly are the "boundaries" of where you can cut into the cube without destroying it? P.S I'm not sure this is the right place to ask this question, seeing as this fourm is more about speedsolving than modding, but it's one of the few cubing fourms I know...