Why is my GuHong bad?

Actually, I have the same dilemma. My Guhong is absolute trash, I have to slow down my turning speed tremendously just to stop it from popping. The pops are not just regular pops, either. The whole cube just crumbles in my hand. To top it off, it's extremely sluggish, even my Rubik's Brand turns faster than it. Even the corner cutting is not as advertised, it cuts about 75% of a cubey, anything more, it just locks up.
 
Last edited:
Actually, I have the same dilemma. My Guhong is absolute trash, I have to slow down my turning speed tremendously just to stop it from popping. The pops are not just regular pops, either. The whole cube just crumbles in my hand. To top it off, it's extremely sluggish, even my Rubik's Brand turns faster than it. Even the corner cutting is not as advertised, it cuts about 75% of a cubey, anything more, it just locks up.

same
The corner cutting problem is probs just because you tightened the cube to stop it popping. Solution: I wore it in with a touch of WD-40 (then wiped it off after 2 minutes). Then I re-lubed and it was ok again. It was a little slugish before but now its really fast, just a shame about the corner cutting (at least it doesn't pop now). Oh and if you did the 48 point edge mod, I found it made my GuHong smoother but pop a little more.

Hope I was a help
 
Same problem with mine. Ive done around 100 solves on it, but still locks up approximately once out of 4 solves. My corners cut about 9/10s of a cubie. Is that good or bad for a guhong? My Alpha II is my best friend, cuts a whole cubie, and smooth as heck. I really prefer it over the guhong. Just saying.
 
Back
Top