I got around to taking mine apart yesterday evening.
I've tried to colour code the comments for clarity.
Edges
First thing I had noticed was the fact that the edges weren't flush, which looks pretty ugly on a white cube. The gaps were pretty big on some pieces so I took the edges apart and found three areas with excess sprue that was hindering the bits from fitting properly.
By
b4p4076 at 2011-05-19
This stuff falls out when you separate the pieces, it is also still stuck along the highlighted area. Just scrape it off with a box cutter.
There is excess plastic build up around these pins, it's mostly the pin that I've highlighted here, but it can also be others on some edges. Box cutter.
Sometimes there's also excess plastic around the holes that the pins go in to that you might need to remove.
Core
By
b4p4076 at 2011-05-19
Needed to shave the the excess plastic sticking out from around the holes on the core. Not that important but my core was pretty bad in that aspect.
Washers
By
b4p4076 at 2011-05-19
Old washers
DaYan 4 washer
Carnage
When I dismantled the core I was shocked. Loads of ground up plastic everywhere.
Although I didn't take a picture, one of the washers had actually gotten stuck on the screw which in turn, was holding the spring under pressure. Lots of plastic shavings/ powder stuck in the springs too. It took some force to separate them. First thing I did was to swap the washers for ones left over from my DY4. The one on the far left of the photo was even bent/ faulty
So yeah, cleaned it all out.
Lube
Lubed the following parts:
Under the screw head
On the bottom of the spring
Under the washer
In the core centers
The core pieces in general
I had already lubed the outer parts.
Conclusion
You'll laugh, but the inner layers run smoother and with less force than the outer ones. It's a proper speed cube now. Now I just need to become a proper 4x4x4 speedcuber
Anybody know a mod for the outer layers? I mean, they don't have to be as fast as those on the X-Cube or anything. Maybe just as easy to turn as the inner layers...