Sorry for the bump, but I tried shock oil in the core and it's great. First I cleaned everything with soap and water, then I reassembled the frame. For each center I put some shock oil into the screw hole (on top of the small washer) and some around it (under the large washer). I then adjusted the tensions and added shock oil between the centers and the core (only the sides that needed it). Finally I lubed the pieces by laying them on newspaper and spraying them with Jigaloo (normally I just pop an edge and spray).
I can't say how much of the improvement is due to the shock oil vs. the cleaning and the larger amount of Jigaloo, but this cube has never felt so good. I got a 15.56 right away (average is 22-23), but I had to tighten it a bit since it was popping a lot. I tightened every side by a quarter turn and now it only pops a little but is still very smooth. I did an average of 50 and it was about a second faster than my previous PB.
Conclusion: clean your cube thoroughly, disassemble to lube, and lube the core (I used 20wt. shock oil, but I imagine other weights, Maru, or Lubix would work well also).