[Video] How to Mod a Type A-V

[amostay2004]

Sorry it took quite long to get this uploaded. Initially wanted to add some solves into the vid but I've been busy cos I just moved to London! =D

So I'll just upload what I have recorded bout a week ago. Didn't put enough effort into the vid but I hope it serves its purpose.

FYI the cube's awesome..if only I can get used to white cubes =/

 

[iasimp1997]

Thanks, bro. I've been looking for one of these.

 

[michaellahti]

I really don't see how this would make much of a difference. You shouldn't even need to corner cut that far.

 

[Vifs]

Thinking about getting the A-V, If I do might try out this mod

 

[Deleted member 2864]

I really don't see how this would make much of a difference. You shouldn't even need to corner cut that far.

A non-modded AV locks up too without this mod from what I hear.

The corner cutting part, though, I think is useless also. Who the heck would misalign a layer by past one edge?

 

[amostay2004]

Well it just generally becomes way better after the mod. You won't know unless you try it yourself.

 

[nlCuber22]

Nice tutorial. This is what I did to mine and I agree it makes it way better.

 

[teller]

All I can tell you is that the Haiyan Memory is fantastic, so the mod seems to work.

 

[Carson]

I really don't see how this would make much of a difference. You shouldn't even need to corner cut that far.

A non-modded AV locks up too without this mod from what I hear.

The corner cutting part, though, I think is useless also. Who the heck would misalign a layer by past one edge?

*sigh*
*raises hand*

 

[Streakist]

Jesus Christ! Cut away from your fingers, not toward them!:fp

 

[koreancuber]

Jesus Christ! Cut away from your fingers, not toward them!:fp

I was thinking the same thing!

 

[Sherwood]

I don't get which 3 edges you do on the corner piece to cut? Like theres so many corners but which ones are the ones that we "polish"

 

[Stefan]

I don't get which 3 edges you do on the corner piece to cut? Like theres so many corners but which ones are the ones that we "polish"

I respectfully recommend you actually watch the damn video.

But since you're apparently incapable to watch or understand it or think for yourself... (and because I think a video is a waste of time for this)...

 

[Sherwood]

Ahh thank you, that's what I've been doing.

 

[Chapuunka]

Jesus Christ! Cut away from your fingers, not toward them!:fp

That's either very difficult, or I'm very stupid (probably the latter). But knives don't hurt THAT much.

 

[amostay2004]

With a bit of logical thinking one should know which sides to sand

 

[Dene]

With a bit of logical thinking one should know which sides to sand

Ya. Clearly the outer edges that have absolutely no contact with any other piece. Because that way you reduce friction with the fingers. Yea that makes sense.

 

[Stefan]

Clearly the outer edges that have absolutely no contact with any other piece. Because that way you reduce friction with the fingers.

No it's because that way your fingers can "cut corners" better. You seriously didn't know that?

 

[Samania]

Jesus Christ! Cut away from your fingers, not toward them!:fp

That's either very difficult, or I'm very stupid (probably the latter). But knives don't hurt THAT much.

LIES!!

 

[mazei]

Jesus Christ! Cut away from your fingers, not toward them!:fp

That's either very difficult, or I'm very stupid (probably the latter). But knives don't hurt THAT much.

LIES!!

The accusation that it was a lie is a lie!