New DIY Type A III Centers

[keyboarddrummer]

I just got a new DIY Type A III. I started to assemble it when I realized that the caps are the same for all of the pieces (except for two with the company logo). I tested getting them on the center pieces (just the cap on the center...no screws yet), and could not find a way to get them off using only what would be available once the cube was assembled (I had to push my screw driver through the screw hole to get the cap off). How are you supposed to remove the center caps once the cube is assembled?

 

[daniel0731ex]

push it from the hole under the centerpiece.

 

[keyboarddrummer]

How would you do this if the cube was fully assembled?

 

[daniel0731ex]

there is more than one hole under there.

 

[liljthedude]

I got a blade and pryed out from the side of the cap.

 

[~Phoenix Death~]

there is more than one hole under there.

That's What She Said

 

[Thomas09]

I just pry it off with a flat head screw driver.

 

[Jokerman5656]

i live by the statement, act then think. but in your case just use the edge of a knife. (dont cut self)

or you could make a spot like on a type C where you can get your nail in there.

 

[yeee707]

How would you do this if the cube was fully assembled?

Dissassemble the cube, then use a paper clip, flathead screwdriver, etc to push the cap off from underneath. Reassemble the cube with all center caps off, play with it and adjust tension, then put caps back on when satisfied.

 

[Robert-Y]

There's a very easy way: use a toothpick/cocktail stick