Corner cutting proportional to edges?

Status
Not open for further replies.

cincyaviation

Master
Joined
Nov 26, 2009
Messages
1,944
Location
Lawrenceburg, IN
WCA ID
2010HOVL02
Maybe this has been commonly known and im just a noob, but it just occurred (did i spell that right?) to me while i was playing with my type f that the amount a cube can cut corners is proportional to how wide the inside part of the edge is (you know, the part that interlocks with all the other pieces). because if the inside of the edge gets caught on the inside of the center piece, then the cube will ccut the corner, but if it doesnt catch it, it will lock up or pop... would this information be useful or did i just write a paragraph for no reason?
not sure if this should go in hardware or puzzle theory...:o
 
the cube will cut corners better if the inner circle is smaller. this is actually one of the design concepts of the newer type A models. i saw a post on mf8 the explains this clearly.
good job for finding out about this, i also discovered about it when i bought my mirror blocks

i was going to post about this but mf8 is currently down

also if the edge's inner part is wider the cube will poop less.
 
I'm pretty sure it has to do more with the spring tension.

i dont think it does, but i could be wrong... proof???

it's generally the spring tension, but the design of the cube will make the cube cut corners very well at high tension. you will understand this if you have a mini type a.


guojia has been very innovative on the design of the DIY cube, and is improving their design a lot lately.
 
Status
Not open for further replies.
Back
Top