DIY lamination?

Karma Cat

Regular
Joined
Nov 24, 2009
Messages
40
Location
Sweden
I'm planning on printing out images and make them into stickers for my cube, only problem is that I don't have access to lamination plastic. Are there any alternatives? Like putting glue on both sides and letting dry to make a protective surface or something?
 
why not just buy them from cubesmith.com its really cheap and you would probably spend less
 
When I made custom stickers, I covered them in mailing tape to protect them. It worked well. You just have to be a little careful because they tend to peel.
 
I tried this once upon a time. But I just took the clear fat mailing tap and placed them on there, cut them out and left some extra so I could roll the type around the edge to the other side. Then I stuck em to the cube.
 
Back
Top