New Poll:Lubricant

Which lube do you use?

  • CRC silicone

    Votes: 52 33.5%
  • Jig-a-loo

    Votes: 36 23.2%
  • other

    Votes: 67 43.2%

  • Total voters
    155
I used to love jig a loo.

However, after chattahoochee 09, I tried some CRC and i instantly became addicted (semi-exaggeration) and i loved the crisp fast feeling, and applied it to everything.

By everything, i also sprayed it on ants, and it worked as an excellent insect killer.
 
Griffon silicone spray

Because CRC and jig-a-loo aren't available in the netherlands (not where I looked) and griffon is a good brand for lubricants
 
Right but it would probably be heavy

Here's an idea. the pieces have 2 layers of plastic. The largest portion is made of a lighter plastic, and there's a thinner, outer layer made of teflon. I wonder if that would work? And would it be a good cube?
 
I use Tableau Dry Lube it works so well. My C4U DIY is nearly fully tightened and it glides like a loose cube but does not pop at all.
Also, its the only Lube I can get due to where I live.
 
I have experience with both the CRC and Jig-a-loo. I have to admit that I think the CRC has yielded better results. Don't get me wrong, a virgin cube can benefit greatly with some jig-a-loo but for best results I tend to CRC spray them instead. Also my experience with Jig-a-loo is that it does NOT melt the plastic. There seems to be varying opinions on that but thats my experience anyway.
 
Why don't they make cubes out of teflon? Then we wouldn't need lubricant, right?

LOL right! Nobody could hold on to them either.. that would be some funny speedsolving... PB = 1 minute and only dropped/picked up 5 times.

On a serious note: I think it would be tougher to manufacture if the material were teflon. It's too soft and in order to have any rigidity, you would have to make the pieces
thick & filled (no thin walls) which would make it alot heavier too. I think it can be done but more than likely the smoothness of turning won't be worth it.
 
Last edited:
Back
Top