Picking out a Megaminx

[doctorgibberish]

Hello, I need some help picking a megaminx because I wanna start speedsolving it.

I already have the GAN megaminx but my hands are too small for it and I accidentally overlubed it back when I didn't know how to lube a cube, which slowed down the cube a lot. I tried wiping it off but it wouldn't come off entirely and it's still.

Should I continue using this or should I get the dayan pro+ or another megaminx?
I want a megaminx that is smooth, stable, and forgiving to slightly inaccurate turns.

Or perhaps another solution so I don't have to get a new megaminx?

 

[ebwzz]

im getting into mega also and i also cane into the issue of gan mega being too big so when i got the dayan mega it was much smaller and fit my hands better. the yuhu v3 is also good, but not the v2 since its big. the dayan is a very good cube and very customizable. i think you would like it.

 

[doctorgibberish]

im getting into mega also and i also cane into the issue of gan mega being too big so when i got the dayan mega it was much smaller and fit my hands better. the yuhu v3 is also good, but not the v2 since its big. the dayan is a very good cube and very customizable. i think you would like it.

Is the dayan forgiving to like slightly inaccurate turns like good corner cutting? Is it stable?

 

[ebwzz]

Is the dayan forgiving to like slightly inaccurate turns like good corner cutting? Is it stable?

i main it and it can corner cut 45 degrees which is very good and its pretty stable. if you end up getting it i would recommend these settings: inner ring: 5, outer ring 3, and magnets 3. i lubed it with the angstrom setup and it became so good. i highly recommend it.

 

[doctorgibberish]

i main it and it can corner cut 45 degrees which is very good and its pretty stable. if you end up getting it i would recommend these settings: inner ring: 5, outer ring 3, and magnets 3. i lubed it with the angstrom setup and it became so good. i highly recommend it

Thank you!

 

[doctorgibberish]

i main it and it can corner cut 45 degrees which is very good and its pretty stable. if you end up getting it i would recommend these settings: inner ring: 5, outer ring 3, and magnets 3. i lubed it with the angstrom setup and it became so good. i highly recommend it.

Whats your turning style js for reference to see if I think your setup would work for me too

 

[ebwzz]

fast, aggressive, and smooth.