Type D Help

Lord Voldemort

He-Who-Must-Not-Be-Named
Joined
Nov 24, 2008
Messages
492
WCA ID
2009PRAS02
I was using a Type A core with my Type D, and I just decided to switch cores to see what it would be like. When I switched back, something weird happened.
On one particular side, the layer gives a resistance to turning. If I try to force it, then the screw starts to unscrew itself from the core. After maybe 15-20 quarter turns, the whole screw comes out, and obviously the layer under it as well.

Have any of you had this problem and fixed it?
Can I get a replacement screw or something? I'm pretty sure the problem is the screw itself.
 
If I remember correctly, I think my DIY came with a spare screw.
But maybe it was a spare washer, I can't remember.

That's helpful.

This used to happen to me, but after more than 15-20 turns. You could try some loctite or superglue, which worked for me. Or... Cube4you sells screw/spring sets: http://www.cube4you.com/index.php?gOo=goods_search_list.dwt&gcat=29&gtype=

I think I also saw individual screws for sale on there for like 2 cents, but I can't find them now.
 
I don't want to buy it off cube4you, because of uber high shipping costs...
But you mentioned superglue/loctite: won't those make it so I can't adjust tension anymore? Is this the issue with the new (type D) screws that everyone hates?
 
Last edited:
Ok, thanks a lot people.
Will normal glue work, do you think?
Since the super glue I have kind of melts plastic, and it may mass up my core.
 
Back
Top