How to take apart a C4Y pyraminx?

The only way to take apart any pyraminx is to take off the tips somehow.

Uhh no?

Just twist a layer degrees, and push out an edge. If the pyra is tight then this could be difficult, but just try to do it like you would to a 3x3.
 
Just curious, Why would you want to take off the tips?

I'm not sure about this kind of pyraminx, but under the tips of all the pyraminxes that I know of, there are screws to adjust the tension.

To get it off, I just stick a knife under the tip, but only barely, and then try pry it off by doing it to all three sides. Don't stick it in too deep. You only want it far enough to break the glue and get the cap off.
 
Back
Top