Square-1 Pieces?

lol...

I'm like two seconds from just taking a picture and uploading it. Its a piece that should fit nicely under the equator cap. It has a hole in the middle, one which would have a screw fit nicely in.

Do you really need me to take a picture of it?
 
Without the spring, the / turns have next to no friction. It's very nice for some turning styles, and bad for others. Try it out both ways and see which you like.
 
I'm probably too late, but I'll post it anyway. You can pop and reassamble a Square-1 without having to take it apart completely:
On a brand new Square-1 you may have to use a bit more force but it should work.
 
Last edited by a moderator:
OK, so the Square-1 works fine now, except three specific caps (two edge caps and one corner cap) keep falling off while solving. I am considering gluing these on. Is that a good idea, or is there a better alternative?
 
Back
Top