Dayan Pyraminx

First Impressions:

It is about the same size as a Moyu, and the stickers are pretty small.

The turning of it is very clicky, but it turns smooth besides the clicking, I think this is because of the location of the ball bearings, on other pyraminxs like Moyu, the ball bearings are on the side of the puzzle, whereas on the DaYan, the ball bearings are inside of it, at the bottom of the center. The edge anchors or whatever are pretty big compared to other pyraminxs.


Fast turning can result in lockups and pops. (the pieces pop out at high speeds lol)

I plan to try to setting this up to make it better, by swapping the ball bearing springs with Moyu, or just removing them all together. I also might try florian modding the centers a tiny bit, like on the ShengShou.

I'll be able to deliver a final verdict when I spend some time with this puzzle.

(going to work on a video version of this)
https://www.youtube.com/watch?v=TYhlNJFy350
 
Last edited:
I did the same this morning and it is a lot better now, but I still want to lube it a bit. Also, a warning to anyone who takes out the ball bearings: springs pop out at you; be prepared. One nearly flew in my mouth...
I lost the spring for one of the tips ;-;
just flew up in the air and I never saw it again
luckily I was able to use the springs from the inner ball bearing springs since I wasn't using them, planning to florian mod the thing tomorrow
 
I lost the spring for one of the tips ;-;
just flew up in the air and I never saw it again
luckily I was able to use the springs from the inner ball bearing springs since I wasn't using them, planning to florian mod the thing tomorrow

I nearly did the same with one of the tips. :P Fortunately I found it up on my shelf like 20 minutes later...
Post how the florian mod turns out! I was considering that too; honestly the only thing keeping it from being my main is those minor lock-ups.
 
Back
Top