How to get my cube faster

JTW2007

BattsMan
Joined
Nov 29, 2008
Messages
1,591
Location
᠎
WCA ID
2008WARL01
So, I have a type A diy and I've been wondering lately how I can get it faster. I already loosened the tension a lot and I'm afraid if I go any more, it may pop too easily. I already lube it and clean in every three weeks or so. Even with all that, it still comes nowhere close to cubes I've felt at competitions. Is there any way to get it faster? Do I need a new cube, or is the best strategy to just break it in more? Thanks.
 
id say break it in more, ur at the exact same point as me with my diy, ive been doing some corner tricks and things to wear it in some but just keep going till you get the pieces worn some more and it should glide :)

Happy Cubing
 
I've had it for a few months, so I'd think it would've broken in by now. It may be that I just have my tension set too loose. I may have to try that technique where you tighten it a lot for, like, a week and break it in then. What about sanding? Anyone recommend/discourage sanding?
 
i had a type a and sanded it slightly to remove imperfection like the little bit if plastic bumps on the corner supporst and center sides and on the edge supports and it did nothing but make it pop less.
and it made it turn smoother...... sooo i see no problem, even with just rounding the edges a bit... but ya what ever floats your boat.
 
:eek::(:confused::(:eek:

That string of emoticons basically conveys my current state. I just tried that technique in the video. I looked at the insides of my edges and he was exactly right about what was happening. I sanded it off, and smoothed it out with some steel wool. When I reassembled my cube, I practically passed out. It turns super slow, pops easily, and makes this horrible screeching sound when you turn it. It's truly terrible. I have two main plans now. Plan A: Post and ask if there's any way I can smooth the pieces(I have seen cubes where they're so smooth you can see yourself in the pieces). Plan B: Figure out which type of cube fits my style best and buy it ASAP.

So. Is there any way I can smooth the pieces down?

EDIT: So, for now what I've done is, since only the edges were affected, hybridize my cube with storebought edges. It's not beautiful, but it's better than it was before.
 
Last edited:
:eek::(:confused::(:eek:

That string of emoticons basically conveys my current state. I just tried that technique in the video. I looked at the insides of my edges and he was exactly right about what was happening. I sanded it off, and smoothed it out with some steel wool. When I reassembled my cube, I practically passed out. It turns super slow, pops easily, and makes this horrible screeching sound when you turn it. It's truly terrible. I have two main plans now. Plan A: Post and ask if there's any way I can smooth the pieces(I have seen cubes where they're so smooth you can see yourself in the pieces). Plan B: Figure out which type of cube fits my style best and buy it ASAP.

So. Is there any way I can smooth the pieces down?

EDIT: So, for now what I've done is, since only the edges were affected, hybridize my cube with storebought edges. It's not beautiful, but it's better than it was before.
Oh, I'm sorry about that. The cube does get more looser, so you will have to to tighten it more.

Sorry. :(
 
No problem. Do you (or anyone) know what the difference is (not in performance, but in hardware) between a type a and a type c?
 
I'm not really sure what cube to try. All I've been able to find by searching is that you need to find a cube that fits your "style". The problem is that I'm not really sure what cube would fit my style.
 
Back
Top