What would happen if I do the following to a Moyu Aolong v2?

RadioactivCuber

Regular
Joined
Jan 5, 2015
Messages
32
Location
West Bengal, India
What would happen if I do the following? -

1) Take the screws and springs out the cube and stretch them to lengthen them.
2) Take the screws and springs out the cube and press and constrict them to shorten them.
3) Don't put the washers when assembling

Does any of the above contribute to corner cutting (for reverse and normal) in any way?

Can I install the Dayan core and screws to my moyu aolong v2
 
What would happen if I do the following? -

1) Take the screws and springs out the cube and stretch them to lengthen them.
2) Take the screws and springs out the cube and press and constrict them to shorten them.
3) Don't put the washers when assembling

Does any of the above contribute to corner cutting (for reverse and normal) in any way?

Can I install the Dayan core and screws to my moyu aolong v2

Dont try it. Not worth the risk. Perfectly good cube.
 
I think that putting dayan springs will solve your problem.

I took out washers from my Aolong v2, and it increased the speed.

I know that the center piece may wear out, but I don't really care.
 
Why would taking out the washers make it faster? I would expect it to be slower from rubbing on the plastic instead of metal.

What I'm curious is what would happen if you cut the springs to be shorter.
 
Why would taking out the washers make it faster? I would expect it to be slower from rubbing on the plastic instead of metal.

What I'm curious is what would happen if you cut the springs to be shorter.

It will make it faster because spring has more space without washer and automatically the cube is less "tight" which make it faster. Same thing will happen if you cut the springs a bit.
 
Back
Top