Search results

R U’ R’ U R U’ R’ U R U2 R’ ...

...nsert. (Use R U’ R’ if the edge does not match with the center, and use Rw U Rw’ if the edge does match with the center.) Also for the final edge make s This step is where you solve the U layer corners and the DFR corner if twisted. You can use TCMLL and [[CMLL]] ...

...BExtension: extend the CPLine to a 1x2x3 block, like in Roux, using <r,u,R,U> (6 – 8 moves) **ii. CP: permute the corners, using triggers like F R F’ or F’ U’ F (mirrored on the B-face) (max. 5 moves (0 – 2 commutator moves plus one ...

...ert the pair while orienting the U layer corners. At this point, the D and U colours should be on separate sides B2 D B2 L2 D2 R2 U2 B2 U F2 U' B L2 R2 D2 R' U' R' U' L' ...

*1 EO - M’ U’ M U2 M’ U’ M *2 EP - U [R U R’ U R U2 R’](bracketed part will be used in corners as well) ...

{{Alg|M U M' U2 M U M'}} {{Alg|(y2) M' U M U2 M' U M}} ...

...at reduces it to this specific cube state. These algorithms are entirely R U generator. It is also part of the [[ECCE]] method. ...

...based off a simple pattern (U R U R’) any of the U moves can be changed to U’ or U2, depending on the case. ...

...the edges of the first layer. Hold the first layer (white face) either in R or in L '''R’ D R E''' (or E’ or E2)* '''R’ D’ R E’''' (or E or E2)** ...

3. dBR square + dFR pair in U ...other algorithm for when the corners to permute are in UBL and UBR: D R' U R D' ...

...he partial cross by using only Rw and U moves rather than 3Rw, Rw, 2L, and U moves, essentially making the remainder of this step [[2gen]]. ...sesqui-line by keeping it on the left side and using only Rw, 3Rw, 2L, and U moves. ...