washing?

llamapuzzle

Regular
Joined
Dec 15, 2007
Messages
102
WCA ID
2008RATT01
When you clean the cubies, can you just wash them in like, the bathroom sink or something and dry them off? What about the sides inside the edges you can reach? If someone could explain how they clean their cubies, that would help a ton.

Thanks to whoever helps!
 
i'm not sure if this is right or anything.... i usually leave mine to soak in the sink or a bowl with some washing up liquid. sometimes i put something on top of them so that they stay submerged . after maybe 10 minutes i just leave them to dry in a towel or something!
 
Use hot soapy water with not to much soap. There really is no right or wrong way to wash your cubes as long as you get the gunk out. I personaly use my fingers to rub out all the gunk when I am washing it. Just make sure you dont soak them toooo long or you will ruin the stickers.
 
I put them in a basin of cold water with a bit of soap, then mix them around for 20 secs, take them out and wipe the dry. I think the wiping actually helps more than the water. It's also interesting because the edges sink, while the corners float because of the air kept in them by the corner caps.

It also helps to use a sink the opposite colour to your cubies, then you can see all the ground up plastic ;)
 
I never soak mine because I don't want the tiles or stickers to come off. Instead, I spray a diluted solution of Simple Green on a rag and wipe each cubie individually. Seems to work well, though it's kind of time consuming.

Brian.
 
does tthe water ruin the tiles from cube smith

I have soaked my cubes many times, using just a small bit of dish washing liquid in a basin of water. I don't put the liquid in too early or I get too many suds. I rattle them around vigorously under the water. Next, I empty the water out, and rinse suds down the drain. Then I put fresh water in the basin, mix the pieces, drain, repeat as needed. When done, I shake the water out of the pocket of each edge piece or corner piece, then blow into the pocket to rid of nearly all the water. For the spindle, I pull the springs on the centers and blow to get rid of water drops. I think the corner cubies might actually get water inside the caps, so I shake them well. I let the cubes dry a bit, then assemble. Finally I hold the cube very firmly and whip my wrist to get water droplets out.

Soapy water might cause some stickers to become less sticky, but I think silicone spray does more damage. I have had no problems with Cubesmith tiles at all, except discoloration if silicone spray contacts them.
 
i usually pour some hot soapy water in a little cup, then take a paper towel, lightly wet a small portion of the towel, then carefully clean the cubie, avoiding stickers/tiles, usually can get the cube pretty clean.
After that I take a dry towel and gently rub down every cubie.
Air dry for a couple of minutes
Reassemble.
 
Back
Top