V-7 Missing Pieces?

[bwatkins]

To all more experienced and knowledgeable than me,
I recently bought a white V-7 i have noticed that 3 of the 8 corners are "hollow." They appear to be missing an insert similar to one you would put on a DIY 3x3x3 corner. It seems odd to me that only 3 of the corners are this way. Is this how YOUR V-7's are or is this a problem?

The first picture is of my "bad" corners (i have 3 of them)
The second is of the "good" corners (shown for comparison)

THANKS!

 

[Vulosity]

All corners are supposed to be hollow. Check your "good" corners from a different "side".

 

[Ellis]

I would check again, I bet you they are all like that.

 

[Me Myself & Pi]

Yeah, my V-Cube 7 & V-Cube 5 are like that too. But my V-Cube 6 isn't, it's weird. I've looked at mine closely & it looks like the Verdes Innovations were going to put caps on them, but decided not to, to save money.

 

[bwatkins]

ok now i see, all 8 corners are missing a piece, but like MM&Pi says, it looks like there is supposed to be a piece there, as there are grooves where one could be. So does this effect the cubes rotation and need to be fixed, or is this 100 percent normal?

 

[rjohnson_8ball]

It is normal for v7 to have no corner caps. I believe they all are created that way.

 

[bwatkins]

ok not to be too picky and annoying here. Buy all of my corners have 2 of 3 caps with one missing. Because its such an expensive product i just want to be sure. Is this the way its supposed to be?

 

[Cheese_Board]

This is because there are no "caps". The corners are hollow and are open on one side.

 

[bwatkins]

THANKS for clarifying