I bought a (red) Type A from puzzleproz around the same time that you did. There were a lot of minor bumps and valleys on the pieces that made for rough turning and occasional lock-ups.
Solution:
Part 1: I Tightened down the screws until there was less than a millimeter clearance and all the faces were difficult to turn, and used that cube exclusively for about two months (surprisingly, my times did not increase too much when I did this). Because I'm not color neutral, the pieces with yellow and white stickers got a lot more abuse than the others under the high tension (I do U turns more frequently than others), so my yellow and white faces ended up very smooth and easy to turn, while the other faces remained a little sluggish.
Part 2: Keep exclusively using that cube! Keep the tension high! The imperfections on your other faces will slowly grind away to match the ones that smoothed out first. This is now by far my best cube.
In other words, just keep using that cube, and only that cube, and eventually your problems will go away.
Note: I thought it was uneven tension that was causing my problems at first, but when I switched my center caps around so that my easiest-to-turn face (the yellow one) was over the spring of the previously most difficult-to-turn face (the red one), the yellow face was still the easiest to turn. Ergo, tension was not the problem. It was the cubies themselves.