Type A problems

El Veintitres

Member
Joined
Jun 28, 2009
Messages
17
Location
East Lansing, Michigan
YouTube
Visit Channel
Hi I purchased a type A diy from Puzzleproz about 3 months ago, and for a while I was quite happy with it's performance. However, lately I've been noticing more and more that despite the tensions all being set evenly, there is significantly more turning resistance on some sides than on others. One layer turns extremely smoothly then there are like four that turn reasonably well and then one that has a lot of resistance. This isn't a huge problem, I mean when I say a lot of resistance I mean it basically turns like a storebought. I just wonder if anyone else has encountered this problem or has any idea of fixing it. Thanks :)
 
I had a similar problem with my Puzzleproz Type A. I could never seem to get all the sides at an even tension. However, after using the cube for a while without touching the screws, the cube seemed to calm-down and stop changing. Now mine is fine. Try leaving the cube without always adjusting the screws for a while and see what happens.
 
I bought a (red) Type A from puzzleproz around the same time that you did. There were a lot of minor bumps and valleys on the pieces that made for rough turning and occasional lock-ups.

Solution:

Part 1
: I Tightened down the screws until there was less than a millimeter clearance and all the faces were difficult to turn, and used that cube exclusively for about two months (surprisingly, my times did not increase too much when I did this). Because I'm not color neutral, the pieces with yellow and white stickers got a lot more abuse than the others under the high tension (I do U turns more frequently than others), so my yellow and white faces ended up very smooth and easy to turn, while the other faces remained a little sluggish.

Part 2
: Keep exclusively using that cube! Keep the tension high! The imperfections on your other faces will slowly grind away to match the ones that smoothed out first. This is now by far my best cube.

In other words, just keep using that cube, and only that cube, and eventually your problems will go away.

Note: I thought it was uneven tension that was causing my problems at first, but when I switched my center caps around so that my easiest-to-turn face (the yellow one) was over the spring of the previously most difficult-to-turn face (the red one), the yellow face was still the easiest to turn. Ergo, tension was not the problem. It was the cubies themselves.
 
The order isn't important. I'd buy the C before getting rid of the A though. That way you don't have to wait on C4Y. Oh, how I wish puzzlepro sold black Cs...
 
It's the original type A.

I know that the problem of loose corners does exist in the original typeA but I've never encountered ur problem. I also heard that the quality of the original type A is not as good as before...Personally I don't really like the original type A. Why don't u try the type Aii? Nearly all the best cubers in China use that kind.
 
Back
Top