Stickers

[Inferno.Fighter.IV]

I just got a DIY Cube and I'm not sure how to apply the stickers. There's a square clear sticker like thing, and I'm assuming you use that to some how put the stickers on, but I'm not sure. I just wanted to make sure I don't do anything stupid.

Thanks in advance!

 

[dChan]

Alright, the lazy way is to take the clear sheet with the stickers on it(DON'T MOVE THE STICKERS!) and then carefully place them on one side of the cube. This is the easiest way and gives you less mistakes. But if you are super particular just take each sticker one by one(try not to get your fingers on too much of the adhesive), and place each one carefully. MAKE SURE THEYMATCH YOUR COLOR SCHEME- otherwise you might have to learn a new scheme.

 

[Inferno.Fighter.IV]

Okay, thank you very much! I think I'm going to do it one by one.

 

[dChan]

Yeah, the way i described is probably what they do in order to mass produce the cube. The way you are about to do is probably the way a cube lover should do. Sadly, I did mine mostly the mass producing way,

 

[Arakron]

Yeah, (assuming its a Chinese DIY) you take the slightly sticky clear plastic sheet and stick that on the non-sticky face of a sticker, using this peel the sticker off the sticker sheet and then place it on your cube.
A note on the color scheme - make sure you have not only the right opposite colors but the right adjacent ones (most have BOY clockwise on a corner). If you're liable to make the mistake you probably haven't memorized this bit of your color scheme (I know I haven't), but in my opinion it's nice to have it the normal way.