Cride5
Premium Member
Lubing cubes is not only a time-consuming chore, but over time may increase the rate of plastic wear. At the moment it seems that manufacturers pay little attention to the plastic used in their cubes, and I think much more could be done to produce cubes using plastic with a much lower coefficient of friction.
The problem with applied lubricants is that over time cube debris combine with them to create an abrasive paste. This increases dynamic friction and also increases wear. Because of this I regularly need to clean and re-lubricate my main speedcube. A similar problem occurs in the use of plastic gears. Example here:
http://www.eng-tips.com/viewthread.cfm?qid=27538
A solution to the problem is to use polymers with a low coefficient of friction. For example, Polytetrafluoroethylene (PTFE) - a soft polymer - can be combined with harder plastics to create a compound with high durability and low friction, see:
http://www.matweb.com/reference/coefficient-of-friction.aspx
I'm sure there are many more compounds available for this type of application, varying in price, hardness and friction coefficient. For example, here is a manufacturer which specialises in these:
http://www.ferret.com.au/c/Dotmar-EPP/Self-lubricating-super-plastics-n705667
No doubt cubes using this kind of plastic would be much more expensive, but if it worked it would certainly be an investment I would be prepared to make.
Are there any plastics experts with more info about the feasibility of this, and are there any cube manufacturers who have/would consider this?
The problem with applied lubricants is that over time cube debris combine with them to create an abrasive paste. This increases dynamic friction and also increases wear. Because of this I regularly need to clean and re-lubricate my main speedcube. A similar problem occurs in the use of plastic gears. Example here:
http://www.eng-tips.com/viewthread.cfm?qid=27538
A solution to the problem is to use polymers with a low coefficient of friction. For example, Polytetrafluoroethylene (PTFE) - a soft polymer - can be combined with harder plastics to create a compound with high durability and low friction, see:
http://www.matweb.com/reference/coefficient-of-friction.aspx
I'm sure there are many more compounds available for this type of application, varying in price, hardness and friction coefficient. For example, here is a manufacturer which specialises in these:
http://www.ferret.com.au/c/Dotmar-EPP/Self-lubricating-super-plastics-n705667
No doubt cubes using this kind of plastic would be much more expensive, but if it worked it would certainly be an investment I would be prepared to make.
Are there any plastics experts with more info about the feasibility of this, and are there any cube manufacturers who have/would consider this?